Call 0845 094 9129 (Mon-Fri 9am-5pm)

Welcome to Go-Liquid.co.uk

Smok Spirals 2.0ml Atomiser

SMOK Spirals 2.0ml Atomiser


The 22mm diameter of Spirals tank compatibles with most mini mods. And the built-in large size coil head adopts Japan imported cotton, brand new coil and precise wicking hole. Joined by adjustable small size air slots and elongated drip tip, all that makes it to be a taste whirlwind that offers you authentic, powerful and charming taste. Yes, it is the Spirals tank that brings your impressive experience.

Availability: In stock

£25.99

* Required Fields

Product Description

Details

SMOK Spirals 2.0ml Atomiser

The 22mm diameter of Spirals tank compatibles with most mini mods. And the built-in large size coil head adopts Japan imported cotton, brand new coil and precise wicking hole. Joined by adjustable small size air slots and elongated drip tip, all that makes it to be a taste whirlwind that offers you authentic, powerful and charming taste. Yes, it is the Spirals tank that brings your impressive experience.

SCHEMATIC DIAGRAM

 

 

6 COLORS FOR YOU

 

There are 6 colors for you, and any one of them can compatible with all mods.

BOTTOM ADJUSTABLE AIRFLOW SYSTEM

 

Spirals Tank/Spirals Plus Tank has 4 small air slots on the bottom, airflow can be adjusted freely, which allows you to have an extremely open draw.

BIG FAMILY OF SPIRALS TANK/SPIRALS PLUS TANK

 

 

DELRIN DRIP TIP

 

The delrin drip tip will bring increased airflow and provide you with powerful draw effects.

TOP REFILL SYSTEM

 

Top refill system makes filling as easy as it gets.

HOW TO BUILD THE RBA

 

1 . Before starting, make sure your hands are clean. 
2. Take RBA deck apart.

 

 

3. Install and position the pre-wrapped coil. Place the coil between the posts and wrap the ends around the screws and tighten up, once all is in place, make sure the coil is fixed in the center and lined up with the air hole, and also make sure the coil is NOT touching the base.
4. Cut the excess ends of the wire off.

 

 

5. Cut a strip of cotton and make sure it’s not too much and not too little.
6. Insert the cotton and placing it in the middle of the coil.
7. Cut the cotton at an angle and make sure it’s not too short and not too long.

 

 

8. Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.

Additional Information

Additional Information

VG Percentage % No